P 11/ 11
Fig. 4
Brush holder complete
Heat sink
Shadowed area
Switch
Terminal
LED circuit
Put Line filter (if used) in this space.
Line filter
（
if used
）
Put Line filter (if used) to the left side of Rib F.
Put the sag of Lead wires of LED circuit
in this space.
Do not put the sag of lead wire that is
connected to Earth terminal (if used)
on Shadowed area and Boss A.
Line filter
（
if used
）
Put Heat sink as drawn.
The projection of Earth terminal (if used) must be faced to the opposite side of Yoke unit or Yoke unit side.
Fig. 3
Put lead wire that is connected to Earth
terminal (if used) in this lead holder.
Boss A
Earth terminal
Projection
of Earth terminal
Yoke unit
OK
（
opposite side of Yoke
unit
）
Projection of Earth terminal
Projection of Earth terminal
OK
（
Yoke unit side
）
NOK sample
Projection of Earth terminal
Rib F
Yoke unit
Yoke unit
Non-insulated terminals protected
by Polyolefin tube
(when repairing LED circuit)
Put Non-insulated terminals protected
by Polyolefin tube (when repairing
LED circuit) inside dotted line.
Makita Corporation
