P 6/ 11
ASSEMBLING
5.
When you assemble Motor section to Gear assembly;
·
Protrude Motor section’s gear into the internal gears in Gear assembly first.
·
The next, check their gears are engaged each other.
·
Finally, push Motor section to Gear assembly while keeping gear engagement firmly.
2
－
8
Brush holder complete
Armature
Yoke unit
4.
Assemble Yoke unit and Armature
to Brush holder complete.
2
－
9
Projection of Housing L
6.
Assemble Speed change lever to Gear ass’y. (Refer to 3
－
2)
7.
Fit the projection of Housing L into the notch of Yoke unit.
Notch of
Yoke unit
2
－
7
Notch of
Yoke unit
Gear
1.
Be sure to assemble so that
the notch in Yoke unit is
positioned on the Gear side
of Armature.
Note:
·
Be careful not to damage
Copper wire of Armature.
·
Be careful not to pinch
your fingers between Fan and
Yoke unit.
2.
Shift the tail of Torsion spring and
hook it to the notch of Brush holder.
Note:
Hold "A" to avoid Torsion
spring slipping off.
3.
Lift up
Carbon brush.
A
Torsion spring
Carbon brush
Makita Corporation
