![background image](http://html1.mh-extra.com/html/maker-made/m2/m2_complete-beginner-assembly-manual_3814814042.webp)
42
M2 ASSEMBLY GUIDE
APPENDIX - TIPS
We recommend attaching a hook to
the Top Beam to hold the M2 when
not in operation. This can reduce
stress on your chains and spring, and
give the M2 a safe place to park.
Always wear safety goggles.
Always clamp the material you’re cutting to the Wasteboard Stud Mounts so it doesn’t move
during operation. You can also securely attach it to the Wasteboard using screws.
Always raise the Z-Height to 3mm above your print surface before you turn on your router
and run your M2.
Never leave your M2 unattended while in operation.
Makerverse nor CNCjs control your router, they only control your M2. You must manually
turn your router on and off.
In case of an error always turn off your router before you turn off your M2.
Always remember to turn on your router before clicking “Run” in Makerverse and turn off
your router after the M2 is paused, stopped, or has completed the project.
It’s a good idea to make sure you’re behind the waste board when you declamp materials, as
they can fall to the ground on your foot. Nobody wants that.
When installing the frame, we recommend a friend help connect the spring and each person
wear safety goggles during stretching. The chain can snap back causing damage to self and
surroundings.
Click here to check out updates on our FAQ section!
This work is licensed under the creative commons Attribution
NonCommercial-NoDerivatives 4.0 International license.
Last Updated 11.09.2020
Version 1.14