220
2.91 Constant voltage source
Circuit 195:
constant voltage source
Setup information
Install the transistor, the diode and the two resistors as shown in
Fig. 2.195
followed by the four jumper
wires. Check the placement on the board again and only then connect the battery.
Components required:
1 x 2N3904 transistor,
1 x red LED, 1 x 2.2 k
Ω
resistor, 1 x resistor (see
Experiment for value),
1 x breadboard, 1 x 9V bat-
tery with clip connector
Fig. 2.195:
constant voltage
source
Experiment
Our circuit ensures a constant voltage at the output, even if load resistance and thus current draw changes
greatly. Output voltage is approximately 1.2V if the load resistance value ranges between 100
Ω
and 10 k
Ω
.
You can measure the voltage at the output using a multimeter.
The circuit diagram for this experiment is shown in Chap. 3, Fig. 3.195.
Summary of Contents for ELECTRONICS EXPERIMENTS BOX
