196
Circuit 171:
Buffer amplifier for condenser microphone
Setup information
Install the transistor, the two resistors and the two ceramic capacitors as shown in
Fig. 2.171
. The three
jumper wires come next. Check the placement on the board again and only then connect the battery.
Components required:
1 x J111 FET transistor,
1 x 2.2 k
Ω
resistor,
1 x 1 M
Ω
resistor,
1 x 1 μF electrolytic
capacitor, 1 x 10 μF
electrolytic capacitor,
1 x breadboard, 1 x 9V
battery with clip con-
nector
Fig. 2.171:
Buffer amplifier for
condenser microphone
Experiment
This circuit is a simple buffer amplifier. The input has high impedance, the output has low impedance. A
signal is not amplified and thus provides the ideal conditions to operate a condenser microphone or an
electret microphone on a normal amplifier port.
The circuit diagram for this experiment is shown in Chap. 3, Fig. 3.171.
Summary of Contents for ELECTRONICS EXPERIMENTS BOX
