84
Circuit 59:
DC-DC converter 9V to 35V with LED
Setup information
Install the two transistors, the two diodes and the four resistors as shown in
Fig. 2.59
. Next, install the
ceramic capacitor, the electrolytic capacitor and the fixed inductance. Make sure that the electrolytic capaci-
tor has a dielectric strength of 160V. The twelve jumper wires come next. Check the placement on the board
again and only then connect the battery.
Components required:
2 x 2N3904 transistors,
1 x 1N4148 silicon diode,
1 x red LED, 1 x 1 k
Ω
resis-
tor, 1 x 10 k
Ω
resistor,
1 x 22 k
Ω
resistor,
1 x 47 k
Ω
resistor,
1 x 220 μH fixed induct-
ance, 1 x 1 nF ceramic
capacitor, 1 x 10 μF/160V
electrolytic capacitor,
1 x breadboard,
1 x 9V battery with clip
connector
Fig. 2.59:
DC-DC converter 9V to
35V with LED
Experiment
This circuit is used to convert a larger DC voltage to a smaller one. The two transistors ensure that strong
current pulses are sent through the fixed value inductor. This results in a very high induction voltage, which
charges the electrolytic capacitor C2 after rectification with D1. There then the highly-transformed output
voltage is available. In our present circuitry the unregulated output voltage is at 35V. The voltage is detected
by the red LED with larger series resistance, which ensures a lower load.
The circuit diagram for this experiment is shown in Chap. 3, Fig. 3.59.
Summary of Contents for ELECTRONICS EXPERIMENTS BOX
