185
Circuit 160:
Needle pulse generator 500 Hz
Setup information
Install the two transistors, the two resistors and the two ceramic capacitors as shown in
Fig. 2.160
The nine
jumper wires come next. Last but not least connect the Piezo element. Check the placement on the board
again and only then connect the battery.
You can significantly increase the sensitivity of the Piezo element by using a sound plate or even a sound
box. Read more about it in Chap. 1.2.3
Components required:
1 x 2N3904 transistor,
1 x 2N3906 transis-
tor, 1 x 10 k
Ω
resistor,
1 x 220 k
Ω
resistor,
2 x 10 nF ceramic
capacitors, 1 x Piezo ele-
ment, 1 x breadboard,
1 x 9V battery with clip
connector
Fig. 2.160:
Needle pulse
generator 500 Hz
Experiment
If everything is wired correctly, you will hear a rhythmic clicking sound coming from the Piezo element. The
refresh rate is approximately 500 Hz.
The circuit diagram for this experiment is shown in Chap. 3, Fig. 3.160.
Summary of Contents for ELECTRONICS EXPERIMENTS BOX
