4
53D0419
IMPORTANT SAFETy INFORMATION
Continued from page 3
11. Keep the area around your fireplace clear of combus-
tible materials, gasoline, and other flammable vapor
and liquids. Do not run fireplace where these are
used or stored. Do not place items such as clothing
or decorations on or around fireplace.
12. Do not use this fireplace to cook food or burn paper
or other objects.
13. Never place anything on top of fireplace.
14. Do not use any solid fuels (wood, coal, paper,
cardboard, etc.) in this fireplace. Use only the gas
type indicated on rating plate.
15. This appliance, when installed, must be electrically
grounded in accordance with local codes or in the
absence of local codes, with the
National Electrical
Code, ANSI/NFPA 70
, or the
Canadian Electrical
Code, CSA C22.1.
16. Do not obstruct the flow of combustion and ventila-
tion air in any way. Provide adequate clearances
around air openings into the combustion chamber
along with adequate accessibility clearance for
servicing and proper operation.
17. When the appliance is installed directly on carpet-
ing, tile or other combustible material other than
wood flooring, you must set appliance on a metal
or wood panel or hearth pad extending the full width
and depth of the appliance.
18. Do not use fireplace if any part has been exposed to
or has been under water. Immediately call a quali-
fied service person to arrange for replacement of
the unit.
19. Do not operate fireplace if any log is broken.
20. Do not use a blower insert, heat exchanger insert,
or any other accessory not approved for use with
this fireplace.
21. Do not operate the fireplace with glass door
removed, cracked, or broken.
22. This unit is approved for bedroooms and bath-
rooms.
CODE APPROVAL
Direct Vent type appliances draw all combustion air from outside of the dwelling through the vent pipe.
These appliances have been tested by CSA and found to comply with the established standards for DIRECT
VENT GAS FIREPLACE HEATERS in the USA and Canada as follows:
LISTED VENTED GAS FIREPLACE hEATER
TESTED TO: ANSI Z21.88/CSA 2.33 STANDARDS
A manufactured home (USA only) or mobile home OEM installation must conform with the
Manufactured Home
Construction and Safety Standard,
Title 24 CFR, Part 3280,
or when such a standard is not applicable, the
Standard for Manufactured Home Installations, ANSI/NCSBCS A225.1
, or
Standard for Gas Equipped
Recreational Vehicles and Mobile Housing, CSA Z240.4
.
IMPORTANT:
PLEASE READ ThE FOLLOWING CAREFULLy
It is normal for fireplaces fabricated of steel to
give off some expansion and/or contraction noises
during the start up or cool down cycle. Similar
noises are found with your furnace heat exchanger
or car engine.
W
ARNING
Never connect unit to private
(non-utility) gas wells. This gas is
commonly known as wellhead gas.
IMPORTANT:
PLEASE READ ThE FOLLOWING CAREFULLy
It is not unusual for gas fireplace to give off some
odor the first time it is burned. This is due to the
manufacturing process.
Please ensure that your room is well ventilated
during burn off — open all windows.
It is recommended that you burn your fireplace for at
least ten (10) hours the first time you use it. Place the
fan switch in the “OFF” position during this time.
