53D0419
35
LOG PLACEMENT
Before you begin
- This unit is supplied with eight ceramic fiber logs. Do not handle these logs
with your bare hands.
Always wear gloves to prevent skin irritation from ceramic fibers.
After
handling the logs, wash your hands gently with soap and water to remove any traces of fibers.
W
ARNING
The positioning of the logs is critical to the safe and clean operation of this heater.
Excessive sooting and other problems may result if the logs are not properly and
firmly positioned in the appliance. Never add additional logs or embellishments
such as pine cones or vermiculite to the heater. Only use the logs supplied with
the unit.
Failure to position the parts in accordance with diagrams below or to use only parts
specifically approved for this heater may result in property damage or personal
injury.
INSTALL LOGS AND ROCK WOOL (EMBER MATERIAL) IN FIREBOX
1. Remove glass frame.
(Refer to Glass Frame Removal, Page 34)
2. Carefully remove logs from wrapping.
3. Place left log (#1) on left end of grate. Align the two (2) pin holes in bottom of log with two (2)
pins on grate. Log #1 will always be to the left of the control panel.
Figure 44
4. Place right log (#2) on right end of grate. Align the three (3) pin holes in bottom of log with
three (3) pins on grate.
Figure 45
LG559
Install left log
Left Log (#1)
Grate
Control Panel
Pins
LG559
Figure 44 -
Install Left Log (#1)
LG560
Install right log
Right Log (#2)
Control Panel
Pins
LG560
Figure 45 -
Install Right Log (#2)
