Maguire Products, Inc.
Rev. June 11, 2020
– ULTRA-600 Touchscreen
61
ULTRA By Maguire
- Ultra Low Energy Dryer
Clean Out Procedure
Dumps the Heating Hopper and/or the Vacuum Chamber. The following explains how to
perform these procedures.
HEATING HOPPER HOT SURFACES:
As with all dryers, there are
HOT SURFACES
to avoid. Temperatures can
reach 350F, (180C). Typically, these surfaces are not at dangerous
temperatures, however all hot surfaces should be avoided.
Do Not Perform a Clean Out Unless ULTRA-600 Dryer is First Properly Shut
Down.
For proper shutdown proceedure, see Startup and Operation on page 24.
During the Clean Out, keep hands and tools clear of all valves. DO NOT reach
into machine during Clean Out.
Using the Heating Hopper Clean Out
The Heating Hopper has a front hatch for access to the full internal height of the Heating
Hopper. The Heating Hopper is non-removable. Prior to opening the front hatch, removal of all
material is recommended. Material in the Heating Hopper can be evacuated by dropping the
material down into the vacuum chamber.
Note: use of the Heating Hopper Manual Dump Valve is optional. Material can be dumped into
the vacuum chamber, then into the retention hopper and conveyed away from the VTA at the
base of the dryer.
Emptying the Heating Hopper
Press
The Clean Out button is located on the Home Screen.
Display will show: Batch Start Clean Out Mode screen.
Both the Dump Heating Hopper screen button and the Heating
Hopper Drain Valve button (located near the upper rear of the
Vacuum Chamber area) can be used to empty the Heating
Hopper.
Press
Confirmation window will appear.
Press
to Dump Heating Hopper and start the Clean Out.
