73
Magtrol Model DSP6001 Dynamometer Controller
Chapter 8 – Computer Controlled Operation
OPERA
TION
Command
Code
Function
Explanation
UA#
Sets auxiliary input scaling to
#.
This command sets the scaling factor for the
auxiliary input to # units/volt. The range is 0.0
to 10000.0. Programmed value # is not saved
at power down.
UE#
Sets encoder pulse count to #. This command selects the pulse count option
for speed transducing.
Values for # are:
0 = 60-bit
1 = 600-bit
2 = 6000-bit
3 = 20-bit
4 = 30-bit
5 = 1-bit
6 = 2-bit
7 = 6-bit
Programmed value # is not saved at power
down.
UI#
Sets dynamometer torque
units to #.
NOTE: For Hp and watts calculations to be
correct, the correct dynamometer torque units
must be specified.
Values for # are:
0 = oz.in.
1 = oz.ft.
2 = lb.in.
3 = lb.ft.
4 = g.cm.
5 = kg.cm.
6 = N.mm.
7 = N.cm.
8 = N.m.
Torque units default to 0 (oz.in.) if out of range.
Programmed value # is not saved at power
down.
UR#
Sets readout torque units to #. This command sets the torque unit conversion
for the torque readout.
Values for # are
0 = oz.in.
1 = oz.ft.
2 = lb.in.
3 = lb.ft.
4 = g.cm.
5 = kg.cm.
6 = N.mm.
7 = N.cm.
8 = N.m.
Torque units default to 0 (oz.in.) if out of range.
Programmed value # is not saved at power
down.
