25
Magtrol Model DSP6001 Dynamometer Controller
Chapter 3 – Installation/Configuration
SETUP
3.2.5.2
Software Configuration
1. Turn on the DSP6001 and proceed to the dynamometer configuration menu. See
Section
3.2.1 – Dynamometer Configuration Menu
.
2. Select TSC1 until HD is reached.
3. Select TSC2 until WB or PB is reached.
4. Press SHIFT to get to the hysteresis setup menu. See
Figure 3–9 Hysteresis Setup Menu.
5. Press TORQUE UNITS button until the desired input unit for TSC1 is reached.
6. Press SHIFT. The display should appear as follows:
POWER
BRAKE STATUS
SET POINT
SET POINT
P
I
D
TORQUE
SPEED
STATUS
Figure 3–18 TSC2 Eddy-Current/Powder Brake Setup Menu
7. Press TORQUE UNITS button and use UP
and DOWN
buttons and Decrease/Increase
dial to set desired scale factor for TSC2.
8.a. If using an Eddy Current Dynamometer, press SHIFT 2 times. The display should appear
as follows:
POWER
BRAKE STATUS
SET POINT
SET POINT
P
I
D
TORQUE
SPEED
STATUS
Figure 3–19 Nominal Speed Setup Menu
Press the AUX SETUP button and use UP
and DOWN
buttons and Decrease/Increase
dial to set desired nominal speed. Press SHIFT 3 times to complete the initial setup and
return to the main menu.
8.b. If using a Powder Brake Dynamometer, press SHIFT 3 times to complete the initial setup
and return to the main menu.
