9
Magtrol Model DSP6001 Dynamometer Controller
Chapter 2 – Controls
GENERAL
INFORMA
TION
2. Press any control button to enable the function shown in blue letters above the button.
3. Press the SHIFT button again to exit the secondary function and return to main menu.
Note:
If the brake status is ON, the SHIFT button will be ignored.
2.2.2
E
nabling
S
aving
F
unction
To save all current programmed settings:
1. Press the SHIFT button two times. The word “SAVING” will appear in the display, as shown
in
Figure 2–3 Saving Function Menu.
POWER
BRAKE STATUS
SET POINT
SET POINT
P
I
D
TORQUE
SPEED
STATUS
Figure 2–3 Saving Function Menu
2. After a few seconds, the menu will automatically return to the main menu display and all
configurations of the unit will be saved into a non-volatile memory.
2.2.3
H
ow
to
u
SE
F
ront
P
anEl
c
ontrolS
and
b
uttonS
2.2.3.1
Controls/Single-Function Buttons
Button
To Use
Function
POWER
Press I to turn power ON Press O
to turn power OFF.
Turns power ON or OFF.
SHIFT
Press this button and release; then
press desired control button.
Enables the function written in blue
above control button.
Press this button two times and
release.
Saves current configuration of unit
to non-volatile memory.
UP/LEFT
Press.
Increases magnitude of change
when adjusting a numerical value
(speed, torque or max. speed).
DOWN/RIGHT
Press.
Decreases magnitude of change
when adjusting a numerical value
(speed, torque or max. speed).
DECREASE /
INCREASE DIAL
Turn clockwise or
counterclockwise.
Increases or decreases the
parameter selected.
