35
Magtrol AN 2000 C
Instruction Manual
The figure shows the different locations of the plug-in
output cards. Each location corresponds to a specific
function: setpoints, analogical and serial outputs.
The options 2RE, 4RE, 4OP and 4OPP are installed in
the M5 connector.
The ANA option is installed in the M4 connector.
The options RS2 and RS4 are installed in the M1
connector.
Up to three output options can be present at a time
and operate simultaneously, but only one from each
category:
- ANALOGICAL
- RS232C or RS485
- 2 RELAYS, 4 RELAYS, 4 PNP or 4 NPN
The BCD output is exclusive and do not allow
installation of any other card. This option is connected
to the main board by means of a 18-pin FLAT cable.
