7 - Introduction to User Interface
DynaFlex II Go| EMV Contactless/NFC Card Reader | Installation and Operation Manual
Page 40 of 55 (
D998200595-100
)
Figure 7-29 - Tapping a Contactless Card / Smartphone
Figure 7-30 – Contactless Read LED Sequence – Read Complete (Connected via Bluetooth LE)
7.9.3
How to Scan Barcodes
To scan a barcode, follow these steps:
1)
Make sure you are using a DynaFlex II Go model that includes a barcode reader, indicated by QR
Code markings on the face of the device surrounding the barcode reader lens (see section
2)
If the barcode being scanned is not on a self-illuminated source such as a smartphone, make sure
there is enough ambient light for the camera to read the barcode. In low light conditions, the barcode
reader will only be able to read self-illuminated sources.
3)
In some solutions, the operator may have to perform an operation in the host software to enable the
barcode reader, or to start a transaction with the barcode reader enabled.