4 - Installation
DynaFlex II Go| EMV Contactless/NFC Card Reader | Installation and Operation Manual
Page 17 of 55 (
D998200595-100
)
2)
Press the
Remove device
button.
4.4
Mounting
4.4.1
About Mounting
DynaFlex II Go products are designed to provide flexible mounting options:
•
The device can be mounted to the host via external clip or embedded lanyard.
4.4.2
How to Mount DynaFlex II Go
This document describes how to use DynaFlex II Go securely. Using the device in any
way other than the approved methods described in this document invalidates the PCI PTS
approval of the device.
Not following the guidelines in this section could damage the device, render it inoperable,
and/or violate the conditions of the warranty.
This section provides information and guidelines for designing the mechanical aspects of a solution that
incorporates DynaFlex II Go products. MagTek strongly recommends vetting and testing solution
designs before finalizing and deploying them, to make sure the design meets all requirements (e.g.,
functional, legal, security, certification, safety, and so on).
When designing the mechanical portions of a solution that incorporates DynaFlex II Go products,
consider the following:
•
Review section
1.1 Key Features and Components
for an overall introduction to the device’s
physical features and what they are called.
•
Review
Appendix A Technical Specifications
•
Review the information below about overall device dimensions and mounting hole locations and use.
•
Review any additional requirements from other agencies, such as PCI and EMV solution certification
requirements, safety ordinances, and so on, which may introduce additional constraints to the design.
Overall dimensions of the device are shown in
. On request, MagTek can provide a 3D model
of the device’s envelope to assist with the mechanical portion of solution design. MagTek strongly
recommends building and testing prototypes with actual devices before finalizing the solution design.
