© 2016 Sensata Technologies
9
Network Communication Protocols
The MagWeb GT needs to have access to the router via a LAN IP
address. The MagWeb GT only searches for and obtains a DHCP IP
address during its powering-up sequence.
Note: The complete initialization sequence can take several minutes
(up to 15 minutes depending on the complexity of the installation).
3. Operating interface. The next screen to appear depends on
whether the MagWeb GT is connected to the internet via LAN
(Figure 14), or is connected via Wireless (Figure 15).
If connected via LAN:
Figure 13, Subsequent Start-up Sequence Display
Figure 14, LAN Connection Operating Interface
LAN IP Address
Current
Power Production
Lifetime Production
(total)
Reporting Inverters
MagWeb-Internet Communication
L: 192.168.1.101 +W
750W 11.45Kwh 06
Setup
LAN IP Address:
The LCD display on the front of the MagWeb GT shows an IP
address (Example: 192.168.1.101) if the connection to the router is
successful (IP addresses vary, check with the router’s user manual
for specifi cs). However, if the LCD displays “192.168.131.228”,
the MagWeb-router connection has not been successful. In that
case, check all the cable connections and reboot the MagWeb GT —
remove the power cable for a few seconds, and then reconnect.
When the MagWeb GT connects to the internet via LAN, enter the
LAN IP address in the computer’s internet browser to log in to the
MagWeb GT’s local network interface.
Searching V4.0
192.168.2.101
Firmware Version
Router-Assigned IP Address
Note: Figures 11 & 12 only appear on power-up if the microinverter
IDs have not yet been programmed into the MagWeb GT. If the
microinverter IDs have been entered, Figure 13 shows.
Summary of Contents for MagWeb GT
Page 1: ...Owner s Manual MagWeb GT ...
