© 2016 Sensata Technologies
5
Installation
2.3
Connecting the Power and Network Cables
1. Connect the supplied power cable to the MagWeb GT’s Power
Connection port (Figure 6).
Note: Per the previous section, the MagWeb GT communicates
with the microinverters using the Power Line Communications
(PLC) protocol through the Power Connection port.
2. Connect the supplied CAT5 network cable to the MagWeb GT’s
Network port (Figure 6).
2.4
Initial Connection to the Internet
There are three ways to initially connect the MagWeb to the Internet:
• A direct CAT5 cable connection to a broadband router.
• A wireless connection to a broadband router.
• Using a PLC bridge to connect to a broadband router.
2.4.1 Connecting Directly using a CAT5 Cable
1. Ensure the CAT5 network cable is connected to the Network port
on the bottom of the MagWeb GT.
2. Connect the other end of the CAT5 network cable to an open
port on the broadband router (Figure 7).
Figure 6, MagWeb GT Cable Connections
Power Connection Port
Network Port
Figure 7, Connecting the MagWeb GT Directly to Router
RESET
Summary of Contents for MagWeb GT
Page 1: ...Owner s Manual MagWeb GT ...
