in
tele
Smart2 Instruction Manual
June 2016
Page 11 of 49
3. INTELESMART2 INSTALLATION
WARNING
BEFORE OPERATING THE RECEIVER FAMILIARIZE YOURSELF WITH ALL SAFETY INFORMATION IN
THIS MANUAL, APPROPRIATE MANUAL SUPPLEMENTS AND ANY OTHER LOCAL, STATE, OR FEDERAL
RULES OR REGULATIONS ALREADY IN EXISTENCE. FAILURE TO FOLLOW THIS WARNING COULD
RESULT IN SERIOUS INJURY OR DEATH AND DAMAGE TO EQUIPMENT.
3.1 PRE-INSTALLATION
1. Transmitter and receiver access code, channel, and project ID must match before the system will
communicate.
2. Be aware of other radio channels in the surrounding area - set your system to a unique channel.
3. Make sure that your equipment is working properly in manual mode prior to system installation.
4. Make sure the power to the receiver is the correct voltage.
5. Disconnect equipment power prior to system installation.
3.2 RECEIVER
UNIT
MOUNTING LOCATION CONSIDERATIONS
Ensure the mounting location is as far as possible from exposed trolley wires and sources of
electromagnetic or radiated noise as possible.
The receiver enclosure is approximately 20cm (8 in) wide by 30cm (12 in) high by 13cm (5.1 in) deep.
The mounting surface must be smooth and continuous. Mounting the cabinet on uneven surfaces could
cause warping or stress internal components.
If possible, avoid installing receiver unit to a surface where high vibration or shock is present. If this
cannot be avoided, use appropriate shock mounts.
3.3 ANTENNA
MOUNTING CONSIDERATIONS
It is best to mount the antenna so that it is visible to the operator. This is usually accomplished by
mounting the antenna under the crane. However, it is not recommended to point the antenna straight
down, as this will cause a “dead” spot directly under the antenna. The antenna should be mounted at a
45 degree angle perpendicular to the operator. Always try to avoid power sources, motors, drives,
brakes, etc., when installing the antenna. If necessary, Magnetek offers an external antenna kit.