in
tele
Smart2 Instruction Manual
June 2016
Page 27 of 49
WARNING
THE ACCESS CODES IN THE RECEIVER ARE UNIQUE AND FACTORY PRESET. DO NOT CHANGE THESE
ACCESS CODES UNLESS YOU ARE REPLACING AN EXISTING RECEIVER AND ITS ACCESS CODE.
CHANGING THIS CODE COULD MAKE IT COMMON WITH ANOTHER RECEIVER ACCESS CODE, WHICH
COULD MOVE OTHER EQUIPMENT. NO TWO SYSTEMS IN ANY LOCATION SHOULD EVER HAVE THE SAME
ACCESS CODES INDEPENDENT OF THE FREQUENCY. FAILURE TO FOLLOW THIS WARNING COULD
RESULT IN SERIOUS INJURY OR DEATH, AND DAMAGE TO EQUIPMENT.
7.3 CONNECTING
THE
INTELESMART2 TO A COMPUTER
The in
tele
Smart2 contains circuits that permit communication with a computer system via USB. This
provides a USB-mini B plug for connection to a computer system.
When plugging in an in
tele
Smart2 to a computer system, it is strongly recommended that a USB isolation
hub, like Magnetek part 195-50645, is used between the in
tele
Smart2 and the computer system.
WARNING
THE
IN
TELE
SMART2
CAN HAVE A DIFFERENT GROUND POTENTIAL FROM THE COMPUTER SYSTEM IT IS
CONNECTED TO, AS THEY HAVE DIFFERENT POWER SOURCES. DIFFERENT GROUND POTENTIALS WILL
DAMAGE EITHER THE COMPUTER SYSTEM OR THE
IN
TELE
SMART2
. AN ISOLATED USB HUB IS
RECOMMENED TO BE UTILIZED TO PREVENT DAMAGE TO THE
IN
TELE
SMART2
, THE COMPUTER
SYSTEM BEING CONNECTED TO THE
IN
TELE
SMART2
, OR BOTH.
7.4 PROGRAMMING WITH RCP
Read the section of the in
tele
Smart2 manual regarding additional operational features to familiarize you
with the features listed below. The in
tele
Smart2 can be programmed using the optional RCP (Radio
Control Programmer) software.
Magnetek RCP software makes the programming of the in
tele
Smart2 easier and allows the programmer
to store all of the in
tele
Smart2 settings in files for later use or reference. The RCP software also allows
the programmer to customize the in
tele
Smart2 display with language descriptions that are project or
machine specific. Help is provided for each function at the bottom of the RCP screen. The RCP software
allows you to select frequency, access code, and communication configuration. Follow the steps below:
Install the RCP Software
Insert the USB flash drive containing RCP 2.x into a USB port on your PC. Navigate to the flash drive and
locate the RCPSetup.msi file. Double clicking this file will start the install process. When the installation is
complete, RCP will be installed on your PC.
