in
tele
Smart2 Instruction Manual
June 2016
Page 31 of 49
Frequency
This section displays the operating Radio Frequency of the receiver. The receiver Radio Frequency is set
by the factory and cannot be modified by the user.
Receiver Name
The receiver name field allows the user to create a custom name for the receiver. The name can be up to
16 ASCII characters long.
Project ID
This section displays the Project ID for the unit. The Project ID is set by the factory and cannot be
modified by the user.
Serial Number
This section displays the serial number for the unit. The serial number of the unit is set by the factory and
cannot be modified by the user.
Access Code
The access code acts as the receiver address. The receiver will only listen to transmitters with the same
address. This feature is selectable by the user.
NOTE: The transmitter must be set with the same access code as the receiver to properly communicate
with each other.
WARNING
THE ACCESS CODES IN THE RECEIVER ARE UNIQUE AND FACTORY PRESET. DO NOT CHANGE THESE
ACCESS CODES UNLESS YOU ARE REPLACING AN EXISTING RECEIVER AND ITS ACCESS CODE.
CHANGING THIS CODE COULD MAKE IT COMMON WITH ANOTHER RECEIVER ACCESS CODE, WHICH
COULD MOVE OTHER EQUIPMENT. NO TWO SYSTEMS IN ANY LOCATION SHOULD EVER HAVE THE SAME
ACCESS CODES INDEPENDENT OF FREQUENCY. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN
SERIOUS INJURY OR DEATH, AND DAMAGE TO EQUIPMENT.
RF Channel
The RF channel is user selectable through the pull down menu. This function is used to prevent
interference with other radio devices. Refer to Section 8 for the user selectable channels for each of the
frequency ranges.
