RVS-DX, Digital Soft Starter Instruction Manual—4/01/04
i
©2004 MAGNETEK
All rights reserved. This notice applies to all copyrighted materials included with this product,
including, but not limited to, this manual and software embodied within the product. This manual is
intended for the sole use of the persons to whom it was provided, and any unauthorized distribution
of the manual or dispersal of its contents is strictly forbidden. This manual may not be reproduced in
whole or in part by any means whatsoever without the expressed written permission of Magnetek.
DANGER, WARNING
,
CAUTION
and
NOTE
Statements
DANGER, WARNING, CAUTION,
and
Note
statements are used throughout this manual to
emphasize important and critical information. You must read these statements to help ensure safety
and to prevent product damage. The statements are defined below.
D A N G E R
DANGER
indicates an imminently hazardous situation which, if not avoided, will result in
death or serious injury. This signal word is to be limited to the most extreme situations.
WA R N I N G
WARNING
indicates a potentially hazardous situation which, if not avoided, could result in
death or serious injury.
C A U T I O N
CAUTION
indicates a potentially hazardous situation which, if not avoided, could result in
minor or moderate injury. It may also be used to alert against unsafe practices.
NOTE:
A NOTE statement is used to notify people of installation, operation, programming,
or maintenance information that is important, but not hazard-related.
Summary of Contents for 188-10130
