32
/
48
❼
Specifies the preset value.
❽
Specifies the upper and lower limits for each comparator group.
②
Navigates forward and backward through the measurement parameter areas for each axis.
③
Specifies the setting of the external start function from the following options.
・
Start
・
Latch
④
RS-232C settings
・
Separator
Specifies the
separator
between values in the measurement data output from the following options.
・
Space
・
CR+LF
・
Output trigger
Specifies the measurement data output mode from the following options.
・
External trigger (low-speed mode)
・
External trigger (high-speed mode)
・
Internal timer (0.2 seconds)
・
Internal timer (0.5 seconds)
・
Internal timer (1.0 seconds)
・
Internal timer (5.0 seconds)
・
Internal timer (10 seconds)
・
Internal timer (30 seconds)
・
Internal timer (60 seconds)
・
Internal timer (300 seconds)
・
Data format
Specifies the measurement data output format from the following options.
・
Mode 1
・
Mode 2
・
Mode 3
For details on each mode, refer to section 8.1.
⑤
Sends the settings made on the Measure Setting window to the MG80-SC.
If the reference point setting is changed, the power must be turned off and on again.
* Do not turn off the power of the MG80-SC while saving the settings.