4.6 TRAINING
The Universal SW must only be operated by trained
personnel. Personnel in training must be supervised at
all times when working with the machine.
Transport and installation, power supply connections,
commissioning, maintenance and repair work must
only be performed by qualified specialist personnel
with machine-specific training.
4.7 PERSONAL PROTECTIVE CLOTHING
The following personal protective clothing. (PPE) must
be worn when operating the Universal SW:
• protective gloves
• safety boots
• a skin-protecting agent
The owner is required to prove PPE for all personnel.
4.8 FAULTY PROTECTIVE AND SAFETY DEVICES
Faulty safety devices can lead to dangerous situations.
If a safety device develops a fault:
1. Switch of the machine immediately.
2. Secure it against restarting.
3. If necessary, disconnect from mains power.
4.9 MODIFICATIONS TO THE MACHINE
Any additions or modifications the Universal SW are
not permitted without the written agreement of the
manufacturer, Magnaflux GmbH. If you want to make
any changes, please contact Magnaflux GmbH first.
4.10 SPARE PARTS AND CONSUMABLES
The use of spare parts supplied by third party man-
ufacturers can be hazardous. Only use original parts
or parts approved by Magnaflux GmbH. Magnaflux
GmbH does not accept any liability for damage caused
by non-approved spare parts or consumables.
5. TRANSPORT
5.1 EQUIPMENT FOR TRANSPORT
To transport the Universal SW, the following means are
required:
• a crane with two trolleys and suitable rope harnesses
• a forklift truck or manually-operated forklift.
WARNING:
Lifted loads can fall and
cause serious personal injury and
property damage.
• Only use transport equipment that is suitable for the
weight and the dimensions of the machine. Check
the information in section 1.2: Technical Data.
• Insert forklift prongs only in the intended admission
points in the undercarriage. Other attachment points
are not permitted.
CAUTION:
Transport, dismantling and
installation of the Universal SW must
only be carried out by specially trained
personnel.
5.2 PREPARING FOR TRANSPORT
1. Decommission the machine prior to transport.
2. Inspect the condition and load bearing capacity of
the floor at the intended installation location and
along the entire transport route.
• The machine must only be installed on a firm,
level surface.
• Comply with relevant local regulations for work
spaces.
• Take note of the technical information provided
in this manual.
3. Determine and mark out the exact installation site.
4. Determine the transport route and remove any
potential obstacles.
5. Keep unauthorised personnel away from the trans-
port route and installation location. Cordon off the
area, if necessary.
6. Check the securing devices on the machine and
attach them if necessary.
• Fix the sleeve carriage
• Fix the magnetising coil
• Fix the UV lamp
14
