1-800-MAGLINE (624-5463)
Page 20 www.magliner.com
CooLift
®
REPLACING DECK POSITIONING (UP/DOWN) SWITCH
TOOLS NEEDED:
#3 PHILLIPS HEAD SCREWDRIVER, #1 FLAT HEAD SCREWDRIVER, 10mm WRENCH
13mm WRENCH, 5/16” WRENCH, SILICONE SEALANT (CLEAR)
Note: It is important to keep the CooLift upright at all times.
1)
Place the CooLift on a level flooring surface.
2) Engage the holding brake.
3) Turn off main power.
4) Remove battery box (see Replacing Battery Box).
5) Remove the jam nut (D) on the cord grip (B) and pull out the rubber insert (E) to allow the cord to
move freely within the fitting.
6) Follow the green wire from the up/down switch (A) down in the cabinet where it plugs into a
connector (F) connected to a blue wire and disconnect it by unplugging it.
7) Disconnect the white wire from the switch solenoid (G) using a 10mm wrench.
8) Disconnect the black wire from the switch solenoid (G) using a 13mm wrench.
9) Slide the boot off the white wire that was connected to the switch solenoid (G).
10) Using the #1 screwdriver and the 5/16” wrench remove the nuts off the screws that mount the up/
down switch to the cabinet. NOTE: Do not try to remove the screws entirely from the switch box,
just hold the screws in place and remove the nuts.
11) Feed the disconnected wires through the cabinet via the cord grip (B) and remove the up/down
switch box (A) from the CooLift.
12) Peel off any silicone that is left on the cabinet or the switch box.
13) Place a neoprene washer (H) on each mounting hole and mount the new up/down switch box (A)
on the cabinet using the #1 screwdriver and the 5/16” wrench.
14) Feed the wires through the jam nut (D), the rubber insert (E), and the section of cord grip mounted
on the cabinet and secure by tightening the jam nut (D) by hand.
15) Fasten the white wire on the switch solenoid (G) and secure using the 10mm wrench.
16) Fasten the black wire on the switch solenoid (G) and secure using the 13mm wrench.
17) Connect the green wire terminal to the blue wire terminal (F) that comes from the pump valve coil.
18) Reinstall the battery box (see Replacing Battery Box).
Item
Qty.
Part
Number
A Operator up/down switch
1
63019
B Cord grip PG-16 (includes D and E)
1
309122
C Hex locknut PG-16
1
309123
D Jam nut
1
n/a
E Rubber insert
1
n/a
F Plug connector
1
n/a
G Solenoid
1
n/a
H Washer, neoprene bonded
2
80730
