1-800-MAGLINE (624-5463)
Page 25 www.magliner.com
CooLift
®
REPLACING FOAM MOUNTING STRIPS
TOOLS NEEDED:
SHARP PUTTY KNIFE, POCKET KNIFE OR RAZOR BLADE
#2 PHILLIPS HEAD SCREWDRIVER
#3 PHILLIPS HEAD SCREWDRIVER
Note: It is important to keep the CooLift upright at all times.
1)
Place the CooLift on a level flooring surface.
2) Engage the holding brake.
3) Turn off main power switch.
4) Remove the back access panel from the cart by removing the mounting screws using the #3
Phillips head screwdriver.
5)
Remove the charger by first removing the U-shaped mounting bracket using the #2 Phillips head
screwdriver, taking care to keep the charger and bracket from dropping once the screws are
removed. Remove charger and bracket from enclosure and set aside.
6) Using a sharp tool, cut or scrape off the existing foam strips from the underside of the enclosure
box.
7) The location for foam strips is 1/2” - 3/4” from the front of the enclosure and approximately 2-1/2”
left and right of the charger mount holes.
8) Mount two adhesive backed foam strips (A) to the underside of the enclosure shelf, oriented front-
back on the enclosure (Figure 1). Press firmly to secure into place.
9)
Remount the charger and confirm the cord is plugged into it. Check the charger to confirm it is in
the ON position by plugging the charger cord into a grounded 115v outlet and check the charger
indicator lights in the right end of the charger.
10) Replace the back access panel using the mounting screws and #3 Phillips head screwdriver.
Item
Description
Qty.
Part #
A
3/4” square foam tape, adhesive
backed - 4” long
2
309217
A
Figure 1