1-800-MAGLINE (624-5463)
Page 10 www.magliner.com
CooLift
®
REPLACING CORNER POST
TOOLS NEEDED:
7/16” WRENCH, 1/2” WRENCH, #3 PHILLIPS HEAD SCREWDRIVER
Note: It is important to keep the CooLift upright at all times.
1)
Place the CooLift on a level flooring surface with the holding brake engaged.
2) Turn off main power switch.
3) Remove the battery box (see Replacing Battery Box for proper removal).
4)
Remove the five screws (C, E) and hex nuts (A, D) that connect the corner post to the CooLift using the #3
Phillips head screwdriver and the wrenches and remove the corner post (B).
5) Position the new corner post in place and secure with the previously removed screws and nuts and tighten
with the #3 Phillips head screwdriver and the wrenches.
6) Replace the battery box (see Replacing Battery Box for proper installment).
Item
Qty.
Part Number
A Hex lock nut - 1/4”-20
3
80675
B Corner post assembly
1
309108
C Screw - 1/4”-20 x 1-1/2” long
3
80105
D Hex lock nut - 5/16”-18
3
80676
E Screw - 5/16”-18 x 1-1/2” long
2
80115
Quantities listed are for one side of the CooLift
B
A
C
E
D
REPLACING FOAM HANDLE SLEEVE
ITEMS NEEDED:
ISOPROPYL ALCOHOL
VISE
Note: It is important to keep the CooLift upright at all times.
1) Remove handle (see Vertical Loop Handle Removal for instructions).
2) With the handle assembly off of the cart, slide the vertical loop handle to be replaced out
of the horizontal handle grip mount by moving it upward taking care to manipulate the
orientation in order to minimize scratching or marking on the aluminum tubing.
3) Wipe down the section of the vertical loop handle from the insertion end to the desired
location of the new sleeve with isopropyl alcohol. NOTE: The illustration shows the
sleeve sliding in place from the upper end of the handle but either end is an acceptable
starting point.
4) Saturate the inside of the new sleeve with isopropyl alcohol to allow for a smooth
application to the handle.
5) With the handle held securely in a vise, gradually work the new sleeve into place by
twisting, pulling and sliding, taking care not to rip the foam.
Part # 302285
