Magio MG-333, Instruction Manual

Page: 20 / 24

17
Warning!
» Do not turn on the device without water.
»
Before filling water, please pull out the plug first.
» Use only distilled water for pour into the water tank. Do not fill the water tank beyond the MAX
indication.
» Do not use hot water, the water temperature should not be higher than +50 °C.
»
Do not add perfume, vinegar, magnetically treated water, starch, descaling agents, ironing aids,
chemically descaled water or other chemicals as they may cause water spitting, brown staining or
damage to your appliance.
» Do not use your bare hand as a supporting surface when you steam.
User manual
- The appliance can be used for creating a natural look and for quick touch-ups. For garments with
tough wrinkles and for a more formal look, it is recommended to use an iron instead.
- You can wrinkle garments more easily if you spread the laundry properly after you have washed
it. Hang the garments on hangers to dry them with fewer wrinkles.
- When you are steaming, press the steamer head against the garment, and pull the sides of the
garment with your other hand to stretch it.
- Keep the steamer head a slight distance away from dresses with frills, ruffles, ruching or sequins.
- For garments with buttons such as shirts, jackets and pants, close the first button to help straighten
the fabric. To steam sleeves, start from the shoulder area and move the steamer head downwards.
Steam while you pull the sleeve diagonally down with the other hand. For shirt pockets, move the
steamer head upwards while pressing against the fabric.
- During the steaming, small wet spots may appear on your clothes. Also because of the steaming,
the clothes may be a little wet. After steaming, leave the clothes to dry before fold in place or wear it.
Operation
1. Make sure that the operating voltage of the appliance corresponds to the voltage of the network.
2. Remove the water tank.
3. Open port for water and carefully fill the water tank with cold water. Do not exceed the mark
«MAX». Close the cower of water filling.
4. Install the water tank back correctly and monitor the water level to prevent water shortages during
use.
5. Lift the steamer head until it locks into place. If it necessary, install the nozzle.
6. Unscrew the power cord for the entire length and insert the power cord plug into the wall outlet.
7. The indicator light will light up. After 1 minute the appliance is ready for use.
8. By pressing the steam supply button, launch the first portion of steam before starting work, as it
may contain water droplets.
9. To steam the clothes, press and hold the steam supply button. For continuous steam supply,
secure the steam button with the lock.
10. When finished, disconnect the appliance from the mains.
11. After about 30 minutes, when the device cools down, drain the water from the tank and remove
the device for storage.
2. Unreel the cord and plug into an outlet.
3. Before using the appliance for the first time, first use a piece of unnecessary fabric, this will
remove any impurities and odors that might have been left by the manufacturing process and to
make sure the surface is clean enough.
Note
Before switching on the unit, make sure that the mains voltage corresponds to the
voltage specified on the body of the unit.
EN