ID Card Printer – User Manual
- 3 -
The information contained in this document is subject to change without notice.
Ultra Electronics Limited shall not be liable for errors contained herein or for incidental consequential damages in connection with the
furnishing, performance or use of this material.
This document contains proprietary information belonging to Ultra Electronics Limited and may not be wholly or partially copied, stored in
a data retrieval system,or used for any purpose other than that for which it was supplied, without the express written authority of Ultra
Electronics Limited. All rights are reserved.
The HoloKote feature is protected by US PATENT No: 5,990,918 and by EUROPEAN PATENT SPECIFICATION EP 0 817 726 B1.
Microsoft and Windows 2000, XP, Vista and Windows 7 and 8 are trademarks of Microsoft Corporation.
Copyright © 2011 Ultra Electronics Limited.
SAFETY INSTRUCTIONS:
To prevent electric shock do not remove covers.
Do not attempt to service the printer yourself.
There are no user serviceable parts inside. In the event of malfunction, refer servicing to your printer’s supplier.
This product is only to be used with the Power Source supplied at point of purchase.
Take care not to spill any liquid on the printer.
Ensure that the power supply cord is not longer than 2 metres in length and includes a properly grounded connection.
When handling the printer avoid touching the thermal printing edge of the thermal print head. Any grease and contamination
will shorten its life.
Before transporting the printer, remove the dye film & card hoppers and pack the printer in its original packaging.
FCC DECLARATION:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
NOTE: changes or modifications to this equipment without the express written authority of Ultra Electronics Limited could
void the user's authority to operate the equipment.
CCC DECLARATION:
If using this printer in Germany:
To provide adequate short-circuit protection and over-current protection for this printer, the building installation must be
protected by a 16 Amp circuit breaker.
Bei Anschluß des Druckers an die Stromversorgung muß sichergestellt werden, daß die Gebäudeinstallation mit einem 16 A-
Überstromschalter abgesichert ist.
声
明
此为
A
级产品，在生活环境中，该产品可能会造成无线电干扰。在这种情况
下，可能需要用户对其干扰采取切实可行的措施。
WARNING:
This is a class A product. In a domestic environment this product
may cause radio interference in which case the user may be required
to take adequate measures.
