28
MAGENTA MONDO MATRIX
26
5. Commands, cont.
New Mondo III Matrix Reporting & Configuration Commands:
The following commands are not supported in legacy Mondo systems.
$GEO - System Geometry (M3)
Read system geometry:
Command: $GEO
<CR>
Response:
xxx,yyy,ii,mm
<LF><CR>
OK>
<LF><CR>
xxx =
Total number of input ports.
yyy =
Total number of output ports.
ii =
Number of inputs per frame (16, 32, 48 or 64 are the only valid choices).
mm =
Frame address of the master-frame in this system.
$RTD - Report temperature data (M3)
Report temperature data, all frames:
Command:
$RTD
<CR>
(One line for each frame)
Response:
frame,ttt
<LF><CR>
frame,ttt
<LF><CR>
OK>
<LF><CR>
Report temperature data, one frame:
Command:
$RTDframe
<CR>
(One line for each frame)
Response:
frame,ttt
<LF><CR>
OK>
<LF><CR>
frame = frame address 0..159
ttt =
Temperature, in degrees Celcius. The temperature value itself can be 1 to 3 digits long, and
will have a leading “+“ or “-“ sign.
CHAPTER 5: Commands
Summary of Contents for Mondo III Matrix
Page 1: ...1 Mondo III Matrix Installation Setup Guide...
Page 43: ...43 41 NOTES...
