30
MAGENTA MONDO MATRIX
28
5. Commands, cont.
New Mondo III Matrix Reporting & Configuration Commands:
$RST – Reset System, all frames (M3)
Reset (soft):
Command: $RST0
<CR>
Response:
OK>
<LF><CR>
(then system resets)
Reset (hard):
Command: $RST1
<CR>
Response:
OK>
<LF><CR>
(then system resets)
Reset & full default:
Command: $RST2
<CR>
Response:
OK>
<LF><CR>
(then system resets)
Soft-Reset:
Similar to a power-up reset. All previous settings & configuration info are retained.
Hard-Reset:
Clears all configuration parameters except system geometry and web-interface parameters.
Reset & Factory Default:
Clears all settings and configuration parameters. This will also disable your auxiliary
serial ports (COM1,2).
USE WITH CAUTION!
$SSP – System Status Panel (M3)
Read status panel, all frames:
Command:
$SSP
<CR>
(One line for each frame)
Response:
frame,aabbccddeeffgghh
<LF><CR>
frame,aabbccddeeffgghh
<LF><CR>
OK>
<LF><CR>
Read status panel, one frame:
Command:
$SSPframe
<CR>
Response:
frame,aabbccddeeffgghh
<LF><CR>
OK>
<LF><CR>
frame =
frame address 0..159
aabbccddeeffgghh =
Hex-digits, one byte for each status indicator (left to right) with a mask for
the color and blink state:
01 = Blu
02 = Grn
04 = Red
08 = Blink
examples:
Off = 00
blue on = 01
green on = 02
red on = 04
yellow on = 06
blinking yellow = 0E
blinking red = 0C
CHAPTER 5: Commands
Summary of Contents for Mondo III Matrix
Page 1: ...1 Mondo III Matrix Installation Setup Guide...
Page 43: ...43 41 NOTES...
