![background image](http://html1.mh-extra.com/html/mafell/971423/971423_original-operating-instructions_3438919025.webp)
-25-
sufficiently
ventilated
room.
The
provided
extraction hose 5 (Fig. 5 - page 3) must therefore
be used as connection of the upper saw guard to
the extraction connection 4. The air velocity must
be at least 20 m/s (65.6 ft/sec.).
Instructions on service and maintenance:
-
Before beginning maintenance and repair work,
pull the connecting cable out of the socket outlet.
-
Only allow an electrician to carry out work on the
electrical parts of the machine.
-
Damaged cables or plugs must be immediately
replaced.
-
The MAFELL customer service must replace the
tabletop, if the table slit has been sawed
exceedingly.
-
Regularly cleaning the machine, especially the
table and the guides of the mobile parts,
constitutes an important safety factor. The power
plug must be pulled before beginning this work.
-
Only original MAFELL spare parts and accessories
may be used. Otherwise, the manufacturer will not
accept any warranty claims and cannot be held
liable.
4 Setting / Adjustment
4.1 Installation / Transport
The machine is delivered in a transportation box.
Check the machine for possible transport damages.
Damage to the packing material may already be
indicative of improper transport. Immediately notify
your machine dealer of transport damages.
The following parts are packed loosely and must be
installed or attached to the machine before start-up:
-
Upper saw guard
-
Extraction hose
-
Branch pipe (Connection of upper and lower
extraction connection)
-
Universal stop
-
Pushing stick
Proceed as follows for assembly:
Upper saw guard
Release the wing screw 2 (Fig. 2 - page 3) by
approx. 5 turns. Press this wing screw and
push the saw guard 1 horizontally onto the
riving knife/splitter 3. Make sure that the guide
piece of the wing bolt is firmly engaged in the
drilling of the riving knife/splitter when you
release the wing bolt. Align the saw guard in
the required position and tighten the wing bolt
2 again.
Extraction hose and branch pipe
First of all, fit the branch pipe 4 (Fig. 5 - page
3) on the hose connector at the lower saw
guard. Connect the extraction connection on
the upper saw guard to the extraction hose 5.
Push this onto the appropriate connection of
the branch pipe.
Universal stop
The installation of the universal stop is
described in chapter 5.8.
Pushing stick / Push handle
The pushing rod 6 that is included in the supply
(Fig. 5 - page 3) can be stored both on the right
as well as on the left longitudinal side of the
machine in the intended fixture between the
moulded lateral transport handles 7.
For storing the pushing handle (special
accessory), use the drillings on the front right
or rear left on the longitudinal sides of the
machine, in which you can insert the pushing
handle. According to requirements, you can
attach a pushing stick to the pushing handle.
For this purpose, place the handle onto the
pushing stick and press both tips into the
timber. Then apply the wing bolt and screw it
in.
The moulded transport handles 7 on both lateral
sides can be used by two persons to transport the
machine.
The height staggered arrangement of the handles on
the longitudinal and transverse sides enables easy
transport of the machine over stairs, whereby the saw
can be held by one person from above and by the
second person from the bottom and therefore
transported horizontally.
The two feet 9 and 10 (Fig. 6 - page 3) of the
underframe can be folded for ease of transport.
Handle recesses are arranged on the front and rear