Q u i c k S t a r t G u i d e
21
12. Press the EFFECTS button in the Bank
Select Section to select Fader Bank 3.
SHIFT
MASTERS
1
-
24
25
-
48
49
-
72
(TRACK)
(MONITOR)
BANK SELECT
EFFECTS
MIC/LINE
TAPE IN
13. Make sure FX1–4 are assigned to the L/R
bus. Turn up the FX1 fader to hear the
Baritone harmony. You can pan it to the
left by selecting PAN in the Master V-Pot
Section and turning the FX1 V-Pot fully
counterclockwise.
14. Turn up the FX2 fader to hear the Mezzo
harmony. You can pan it to the right by
turning its V-Pot fully clockwise.
15. Turn up the FX3 and FX4 faders to hear
the reverberation effect on all three parts.
Using the Vocal Studio
From the screen:
1. Click on Aux 1 in the V-Pot Select Section.
Click on the V-Pot on the channel playing
back the lead vocal track and bring it up to
0 dB (about 2 o’clock) to route the signal
to Aux 1 send and the internal FX card.
2. Click on Card A in the lower menu bar to
open the Vocalist Control Panel.
3. Click on “Harmony” in the upper-right corner
of the control panel (just below Aux 1).
4. Make sure the OUTPUT MODE is set to
Stereo.
5. Click on “SmartKey” under CONTROL
MODE in the upper part of the control
panel.
6. Turn off voices 3 and 4 by clicking in the
VOICE MUTING box at the bottom of the
control panel.
7. Click on the Interval button on the left side
of the control panel. This determines how
much higher or lower the harmony part is
from the lead part. Click on the slider for
voice 1 and move it down to Baritone.
Click on the slider for voice 2 and move it
up to Mezzo.
8. Click on the Gender button on the left side
of the control panel. At zero, the voice is
unmodified. Click on the slider for voice 1
and move it down to apply increasing male
characteristics to the Baritone harmony
voice. Click on the slider for voice 2 and
move it up to apply increasing female
characteristics to the Mezzo harmony voice.
General Guidelines
