215953
20
Revision A
2.2
Installing Swath Compressor
Follow these steps to install the swath compressor onto an M1 Series Windrower. The swath compressor weighs
approximately 180 kg (400 lb.).
2.2.1
Installing Frame
The swatch compressor frame consists of the front, left, and right supports, and the rock shaft. These parts were unpacked
from the shipping crate in the previous procedure.
1021852
A
B
Figure 2.9: Front Support
1.
Loosely attach bar clamps (A) to each side of the front
support with two M10 bolts and nuts (B).
1021865
A
B
B
C
C
Figure 2.10: Front Support on Windrower Frame
2.
Position front support (A) below the windrower frame at
the cab end and adjust bar clamps (C) to hold the support
in place. Tighten bolts (B) sufficiently to hold the support.
