UNLOADING AND ASSEMBLY
Form 169018
20
Revision C
3. Start engine, and activate HEADER TILT
switches on GSL to extend or retract center-
link cylinder so that the hook lines up with the
header attachment pin.
4. Stop
engine.
5. Push down on rod end of link cylinder (K) until
hook engages pin on header, and is locked.
6. Check that center-link is locked onto header
by pulling upward on rod end of cylinder.
CAUTION
Check to be sure all bystanders have cleared
the area.
7. Start engine, and proceed to step g.
HYDRAULIC LINK WITH OPTIONAL SELF-
ALIGNMENT KIT
1. Adjust the position of the center-link cylinder
with the REEL UP and REEL DOWN
switches, and HEADER TILT switches on the
GSL to position the hook above the header
attachment pin.
2. Lower the center-link onto the header with
REEL DOWN switch until it locks into position
(handle is down).
g. Raise the header fully with the HEADER UP
switch on the GSL. Stop engine, and remove key.
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header.
h. Engage lift cylinder stops on both lift cylinders.
(continued next page)
K
HEADER TILT UP
HEADER
TILT DOWN
HEADER TILT UP
HEADER
TILT DOWN
REEL UP
REEL DOWN