UNLOADING AND ASSEMBLY
Form 169018
16
Revision C
STEP 8. INSTALL AM/FM RADIO
Provision has been made for installation of AM/FM
radio. The mounting is designed to fit a DIN E
style radio with a depth of
“X”
= 161 mm, and
having a 5 mm threaded stud centered on the rear
for support.
Provision has been made for adjustments should
the radio fall outside these parameters.
a. Ensure the battery disconnect switch is turned to
the OFF position, and the ignition is turned to the
OFF position.
b. Remove radio panel by removing four screws (A).
c. Remove screw and nut (C) to remove support (D)
from panel. Retain metric nut (E) and lockwasher.
d. Remove the cut-out by cutting the tabs (B) in the
panel. Remove sharp edges on panel.
e. Locate receptacle (F) (supplied with radio) in
opening, and secure by bending tabs (G) on
receptacle against panel.
f. Insert radio into receptacle, and attach radio
bezel. Ensure radio locks into position, and
faceplate (H) is against the panel.
g. A six-pin connector for the radio is included in the
wiring harness.
In order to mate properly with this connector, the
radio must have a six-pin connector (Packard
#2977042), and have a terminal arrangement as
follows:
(continued next page)
C
E
D
X
B
G
F
H
A
