UNLOADING AND ASSEMBLY
Form 169018
26
Revision C
HYDRAULIC LINK WITH OPTIONAL SELF-
ALIGNMENT KIT
1. Adjust the position of the center-link cylinder
with the REEL UP and REEL DOWN
switches, and HEADER TILT switches on the
GSL to position the hook above the header
attachment pin.
2. Lower the center-link onto the header with
REEL DOWN switch, until it locks into position
(handle is down).
CAUTION
Check to be sure all bystanders have cleared
the area.
e. Raise the header fully with the HEADER UP
switch on the GSL. Stop engine, and remove key.
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header.
f.
Engage lift cylinder stops on both lift cylinders.
g. Install pin (A) through each boot and foot, and
secure with hairpin.
IMPORTANT
Ensure pin (A) is fully inserted, and
hairpin is installed behind bracket on
boot.
h. Remove lynch pin from pin (J) in stand (K).
i.
Hold stand and remove pin (J).
j.
Reposition stand to storage position by inverting
stand, and re-locating on bracket as shown.
Reinsert pin (J), and secure with lynch pin.
k. Remove pin from storage position (L) in linkages
on both sides, and insert in hole (M) to engage
float springs. Secure with lynch pin.
(continued next page)
J
K
L
M
HEADER DOWN
HEADER
TILT DOWN
REEL UP
REEL DOWN
HEADER TILT UP
HEADER UP
A
