UNLOADING AND ASSEMBLY
169558
Revision
D
23
STEP 10. ATTACH HEADER
A. D-SERIES HEADER
IMPORTANT
A light header float kit may need to be
installed, depending on the header
size and configuration.
I. CONFIGURE
HYDRAULICS
The M105 windrower must be fitted with a
draper drive basic kit to operate the
D-Series draper headers.
Windrowers equipped with D-Series hydraulics
have four header drive hoses on the LH side,
and up to five reel drive hoses on the RH side.
If necessary, obtain kit MD #B5577 from your
MacDon Dealer, and install it in accordance with
the instructions supplied with the kit.
II.
ATTACH HEADER BOOTS
IMPORTANT
To prevent damage to the lift system
when lowering header lift linkages
without a header or weight box
attached to windrower, ensure that
float engagement pin is installed in
storage location (A), and
NOT
installed at hole location (B).
If
NOT
installed, attach draper header boots
(supplied with header) to windrower lift linkage
as follows:
a. Remove pin (C) from boot (D).
(continued next page)
B
A
C
D
DRAPER HEADER DRIVE HYDRAULICS
