UNLOADING AND ASSEMBLY
169558
Revision
D
25
f. Connect
center-link:
HYDRAULIC LINK
1. Activate HEADER TILT cylinder switches on
Ground Speed Lever (GSL) to extend or
retract center-link cylinder (G) so that the
hook lines-up with the header attachment
pin.
WARNING
Stop windrower engine, and remove key
before making adjustments to machine. A
child or even a pet could engage the drive.
2. Stop engine, and remove key from ignition.
3. Push down on rod end of link cylinder until
hook (H) engages pin on header, and is
locked.
IMPORTANT
Hook release (L) must be down to enable
self-locking mechanism. If the release is
open (up), manually push it down after
hook engages header pin.
4. Check that center-link is locked onto header
by pulling upward on rod end of cylinder.
5. Proceed to step g. in next column.
MECHANICAL LINK
WARNING
Stop windrower engine, and remove key
before making adjustments to machine. A
child or even a pet could engage the drive.
1. Stop engine, and remove key from ignition.
2. Loosen nut (M), and rotate barrel (N) to
adjust length so that the link lines-up with
header bracket.
3. Install pin (O), and secure with cotter pin.
4. Adjust link to required length for proper
header angle by rotating barrel (N). Tighten
nut (M) against barrel. A slight tap with a
hammer is sufficient.
CAUTION
Check to be sure all bystanders have
cleared the area.
g. Start engine, and press HEADER UP switch to
raise header to maximum height.
NOTE
If one end of the header does
NOT
raise fully, the lift cylinders require
re-phasing. Proceed as follows:
1. Press and hold the HEADER UP switch until
both cylinders stop moving.
2. Continue to hold the switch for three to four
seconds.
3. Cylinders are phased.
(continued next page)
O
N
M
L
H
HEADER UP
HEADER TILT UP
HEADER DOWN
HEADER
TILT DOWN
