UNLOADING AND ASSEMBLY
169558
26
Revision D
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header, and before going under header for
any reason.
h. Cylinder stops are located on both header lift
cylinders on the windrower. Engage lift cylinder
stops on both lift cylinders as follows:
1. Stop engine, and remove key from ignition.
2. Pull lever (P), and rotate toward header to
release and lower cylinder stop (Q) onto
cylinder.
3. Repeat for opposite lift cylinder.
i. Install pin (F) through header leg, (engaging
U-bracket in lift linkage) on both sides, and
secure with hairpin.
j. Raise
header
stand (R) by pulling pin (S), and
lifting stand into uppermost position. Release pin
(S).
k. Remove pin from storage location (T) in linkage,
and insert in hole (U) to engage float springs.
Secure with hairpin.
l. Disengage lift cylinder stop by turning lever (P)
downward to release and lower stop until lever
locks into vertical position.
m. Repeat for opposite lift cylinder stop.
(continued next page)
T
U
P
R
S
F
P
Q
