HEADER OPERATION - GENERAL
Form 169552 / 169554 / 169555
79
Revision A
Change header angle as follows:
HYDRAULIC CENTER-LINK (OPTIONAL)
a. To decrease (flatten) header angle, operate
HEADER TILT UP switch on GSL handle so that
cylinder (A) retracts. The CDM display will show
a reading on the lower line (B) of decreasing
value between
00.0 and 10.0
.
b. To increase (steepen) header angle, operate
HEADER TILT DOWN switch on GSL handle so
that cylinder (A) extends. The CDM display will
show a reading on the lower line of increasing
value between
00.0 and 10.0
.
c. The HEADER TILT switch can be deactivated to
prevent inadvertent header angle changes when
pressing the header height control switches.
Refer to paragraph 5.18.5
Cab Display Module
(CDM) Programming
.
1. Switch to PROGRAM mode on CDM.
2. Press SELECT until SET CONTROL
LOCKS? is displayed.
3. Press to display HEADER TILT.
4. Press to LOCK (deactivate) the
control.
5. Press PROGRAM to exit.
d. Periodically check the operation of the hook
locking mechanism, and ensure that it is working
properly as follows:
1. If header is attached to windrower,
disconnect center-link hook from header by
pulling up on handle (A) to release the
locking device, and then lifting the hook off
the header pin.
2. Lower the handle into the
lock
position.
3. Push up on pin (B) only. Handle should
catch on casting, and pin should not lift.
(continued next page)
A
B
C
A
HEADER
TILT DOWN
B
HEADER
TILT UP