WINDROWER OPERATION
Form 169552 / 169554 / 169555
66
Revision A
6.3.8.2.1 From Field to Transport Mode
a. Set header on the ground (“field position”).
DANGER
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
b. Disconnect hydraulic and electrical connections:
1.
Left Side
- Store hydraulic hoses and
electrical cable into the “storage position”.
See Header Operator’s Manual.
2.
Right Side
- Release the multi-link, and
place into “storage position” on windrower.
See Header Operator’s Manual.
c. Retrieve temporary lift pin from “storage
location” on weight box, and install into rear hole
(A) at the top of the lift arms for additional lift
height for transport wheel deployment.
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header.
d. Raise header to full height, stop engine, and
engage safety locks on lift cylinders.
e. Deploy header slow speed transport system.
See Header Operator’s Manual.
f. Remove float pin from engaged position (B), and
insert in storage location (C). Secure with lynch
pin.
g. Remove pins (D) from lower end of lift linkages.
NOTE
Pins (D) are also used to secure weight
box to windrower linkage.
h. Disconnect the center-link as follows:
HYDRAULIC LINK - OPTIONAL
1. Pull up on latch (E), and locate latch into
notch (F) on top of hook.
(continued next page)
D
B
C
A
D60 SHOWN
E
F