MacDon M 2014 Series, Original Instruction

Page: 109 / 238

ASSEMBLING THE WINDROWER
7. Cold Start: engine temperature below 40°F (5°C).
NOTE: Engines are not equipped with cold start
assist system.
Follow Step 6, page 98 .
Engine will cycle through a period where it appears to
labour until engine warms up.
NOTE: Throttle is nonresponsive during this
time as engine is in WARM UP mode.
This mode will last from 30 seconds to
3 minutes depending on temperature.
After engine has stabilized and is idling
normally, throttle becomes active.
IMPORTANT:
Do NOT operate engine above 1500 rpm,
until engine temperature gauge is above
100°F (40°C).
Table 6.1 Troubleshooting
Problem Solution
Controls not in NEUTRAL Move GSL to NEUTRAL.
Move steering wheel to locked position.
Disengage header clutch.
Operator’s station not locked Adjust position of operator’s station.
Ensure lock is engaged.
Neutral interlock misadjusted Refer to the windrower technical manual.
No fuel to engine Fill empty fuel tank.
Replace clogged filter.
Old fuel in tank Drain tank.
Refill with fresh fuel.
Water, dirt, or air in fuel system Drain, flush, fill, and prime system.
Improper type of fuel Use proper fuel for operating conditions.
Crankcase oil too heavy
Use recommended oil.
Low battery output Have battery tested.
Check battery electrolyte level.
Poor battery connection Clean and tighten loose connections.
Faulty starter Refer to the technical manual.
Wiring shorted, circuit breaker open Check continuity of wiring and breaker (manual reset).
Faulty injectors Refer to the technical manual.
169886
99
Revision A