MacDon M 2014 Series, Original Instruction

Page: 115 / 238

ASSEMBLING THE WINDROWER
7. A six-pin connector for the radio is included in the
wiring harness.
In order to mate properly with this
connector, the radio must have a six-pin connector
(Packard #2977042) and have a terminal arrangement
as shown at right.
8. Attach two additional wires in the wiring harness to
the radio:
a. Circuit 503: Red with 1/4 in. female blade
terminal. This is a live wire provided for powering
a radio clock/memory, if these exist on your radio.
b. Circuit 315: Black ground wire attaches to
radio body.
9. Plug cable from antenna into radio.
NOTE: An approved radio package is available
from Radio Engineering Industries (REI)
of Omaha, Nebraska.
Figure 6.144: Six-Pin Connector
A - Left Speaker Power + B - Left Speaker Ground –
C - Radio Ground – D - Radio Power + (Live When
Ignition is On)
E - Right Speaker Power +
F - Right Speaker Ground –
10. Attach stud (supplied with radio) to center rear of radio.
11. Attach support (B) to stud on back of radio chassis, with
lock washer and metric nut (A) that was supplied with
the support.
Support can be attached to chassis in multiple
locations to allow for proper mounting of radio.
12. Reinstall radio panel with original screws.
Figure 6.145: Radio and Support
13. Adjust bracket (A) if necessary by loosening nuts (B) to
allow radio to slide into opening and securely capture
support (C).
14. Retrieve antenna from inside cab and remove
protective cover from base end.
Figure 6.146: Radio and Support
169886
105
Revision A