MacDon HC10, Operation And Parts Manual

Page: 147 / 156

REFERENCE
7.1.8 Tapered Pipe Thread Fittings
Assemble pipe fittings as follows:
1. Check components to ensure that fitting and port threads are free of burrs, nicks and scratches, or any form of
contamination.
2. Apply pipe thread sealant (paste type) to external pipe threads.
3. Thread fitting into port until hand-tight.
4. Torque connector to appropriate torque angle. The Turns From Finger Tight (TFFT) values are shown in Table
7.14 Hydraulic Fitting Pipe Thread, page 137 . Make sure that tube end of a shaped connector (typically 45º
or 90º) is aligned to receive incoming tube or hose assembly. Always finish alignment of fitting in tightening
direction. Never back off (loosen) pipe threaded connectors to achieve alignment.
5. Clean all residue and any excess thread conditioner with appropriate cleaner.
6. Assess final condition of fitting. Pay special attention to possibility of cracks to port opening.
7. Mark final position of fitting. If a fitting leaks, disassemble fitting and check for damage.
NOTE:
*Over-torque failure of fittings may not be evident until fittings are disassembled.
Table 7.14 Hydraulic Fitting Pipe Thread
Tapered Pipe
Thread Size
Recommended
T.F.F.T
Recommended
F.F.F.T
1/8–27
2–3 12–18
1/4–18
2–3 12–18
3/8–18 2–3 12–18
1/2–14
2–3 12–18
3/4–14 1.5–2.5 12–18
1–11 1/2 1.5–2.5 9–15
1 1/4–11 1/2 1.5–2.5 9–15
1 1/2–11 1/2 1.5–2.5 9–15
2–11 1/2 1.5–2.5 9–15
214033
137
Revision A