16. Engage safety prop on the windrower’s lift cylinder
as follows:
a.
Pull lever (A) and rotate toward header to release,
and lower safety prop onto cylinder.
b.
Repeat for opposite lift cylinder.
IMPORTANT:
Ensure the safety props engage over cylinder
piston rods. If safety prop does not engage
properly, raise header until prop fits over the rod.
Figure 3.36: Cylinder Safety Prop
17. Install pin (B) through the header leg (engaging
U-bracket in draper header support) on both sides and
secure with a hairpin (A).
18. Raise header stand (D) to storage position by pulling
spring pin (C) and lifting stand into uppermost position.
Release spring pin.
Figure 3.37: Header Leg
19. Disengage
safety
prop
by
turning
lever
(A)
downward to raise safety prop until lever locks into
vertical position.
NOTE:
If safety prop will not disengage, raise header to
release the prop.
20. Repeat for opposite side.
Figure 3.38: Cylinder Safety Prop
214017
31
Revision A
