3.3
Connecting Center-Link
The procedure for connecting the center-link varies depending on the type of center-link installed on the machine.
Refer to the applicable topic:
•
3.3.1 Hydraulic Link without Self-Alignment Kit, page 23
•
3.3.2 Hydraulic Link with Optional Self-Alignment Kit, page 27
3.3.1
Hydraulic Link without Self-Alignment Kit
The following connection procedure applies to M1240 windrowers with a hydraulic center-link and without the
self-alignment kit.
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator’s seat for any reason.
1.
Stop windrower engine and remove key from ignition.
2.
Relocate pin (A) in frame linkage as required to
raise the center-link (B) until the hook is above the
attachment pin on the header.
IMPORTANT:
If the center-link is too low, it may contact the
header as the windrower approaches the header
for hookup.
Figure 3.14: Hydraulic Center-Link without
Self-Alignment Kit
3.
Remove hairpin (A) from pin (B), and remove pins from
both header legs.
CAUTION
Check to be sure all bystanders have cleared the area.
4.
Start engine.
Figure 3.15: Header Leg
214017
23
Revision A
