Mounting the corn head on the combine
26
6.2 Other steps following the securing of the adapter on the combine
WARNING!
DO NOT attempt the following steps until the corn head is
properly attached and secured to the combine, and the combine
feeder lift cylinder stop is engaged!
Remove the lifting bar from the
snapping unit.
Place the central snout on to the rear dividers pin (1)! For easier mounting ,first
loosen the rear dividers pin which is fixed by a hex bolt (2), fix the central snout from
the outside with countersunk-head bolt (3), then tighten the earlier loosened hex
bolts! To make easier the mounting look at the parts catalogue 21/A page.
Adjust the arm which is used for central divider shoring (4), according to the desired
height, and then fix it with a hex bolt (5) and a lock nut (6)! If finer adjustment is
needed, this can be done, with a nut in the back (7).
In case of the outer dividers proceed as described above as well.
After completing the above-described, connect the drive-connecting elements, and
drive shaft as well!
Summary of Contents for C Series
