MacDon C Series, Operator'S Manual

Page: 23 / 70

Mounting the corn head on the combine
22
6.1.8 ACROS
Mounting the corn head to the feeder house:
1. Preparing the feeder house for mounting the corn head.
1.1. Remove the frame and the spacer with the drop-in roll from the feeder
house.
1.2. Loosen the blocks on the bottom spring, remove the side spring blocks with
faders. Also remove the two springs which are above the feeder house.
1.3. Lift the lower drive shaft on the feeder house, freeing the lower supporting
and fixed.
1.4. Unscrew the B 16 - bolts until the cotter pin collision. Remove the B 12 bolts.
Turn the supports to be coincident with the threaded holes with the opening
of the side panel, insert the B 12 bolt and screw it in until it stops. Tighten the
M16 bolt until it stops. Released the feeder house lower drive shafts fixation.
1.5. Mount the spacer (1) with fixed finger on the feeder house, and tighten the
removed screws.
1.6. Mount the two faders on the right and left of the feeder houses console with
a cotter pin (5) to the shaft (4).
1.7. On the feeder house’s right side front axle remove the z=18 pinion and
mount the z=16 pinion on. Re-
move the transit link in the
chain and mount the drop-in
drive chain in its place. The
chain contour must be in plane
and adjust the chain tension.
2. Prepare the corn head for mounting
on the feeder house.
The isolation plate (3) should be
turned, so that it won't hang out from
the corn heads side plate.
3. Mounting corn head on the feeder
house.
Lower the feeder house so that the,
spacers(1) hook pin (6) is lower than