5
Performing Predelivery Checks
CAUTION
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator’s seat for any reason.
IMPORTANT:
To avoid machine damage, check that no shipping dunnage has fallen down between auger and pans.
1.
Perform final checks and adjustments as listed on the
Predelivery Checklist
(yellow sheet attached to back of
this instruction –
Predelivery Checklist, page 111
) to ensure the machine is field-ready. Refer to the following
pages for detailed instructions as indicated on the checklist.
2.
The completed checklist should be retained either by the Operator or the Dealer.
5.1
Checking Drive Belts and Chains
1.
Open shield on header right-hand side.
2.
Check knife drive timing belt (A). It should deflect
14 mm (0.55 in.) when a load of 22–30 N (5–6.5 lbf)
is applied at mid-span.
Figure 5.1: A40-D Header RH Side
3.
Open shield on header left-hand side.
4.
Check knife drive timing belt (A). It should deflect
14 mm (0.55 in.) when a load of 22–30 N (5–6.5 lbf)
is applied at mid-span.
5.
Check knife drive V-belts (B). They should deflect 4 mm
(3/16 in.) when a load of 35–40 N (8–12 lbf) is applied
to each belt at mid-span.
6.
Close shields.
Figure 5.2: A40-D Header LH Side
147913
77
Revision A
Summary of Contents for A40-D
Page 2: ...A40 D Self Propelled Windrower Auger Header Published May 2016 ...
Page 76: ......
Page 100: ......
Page 119: ......
